Posiflex TX-4200 - Manual (Page 6)

Page 6
d)
Wireless LAN adaptor in Mini-PCI-E interface.
e)
RJ-45 to DB9 connector cable.
INSTALLATION GUIDES
Hardware Power Switch
The power switch located in the front bezel of main unit. It is a pushbutton
switch and controls the power on/off of the whole system.
This power switch turns the system on when pushed
only. This switch turns the system off when pushed
again during power on status. However, if the system
hangs due to any reason such as software resource
conflict, a simple push on the switch in 10 sec may turn
off the power.
Note: There must always be at least 10 seconds waiting before switching
on again once the system is powered off successfully.
Indicators of power, status and HDD
There are two indicator LED modules serving for several purposes at front
bezel. For HDD indicator, it will flash orange light when the
HDD is operating. The relationship between the indicator
status and other conditions of “Power LED” is summarized in
the following table:
CAUTION: Before any installation or cable connection to the set, please
always make sure that the system is turned off and the external power
source to the set is removed to prevent electric hazard! Never touch any
metal pin in the connectors or circuits to avoid high voltage hazard or
Indicator Terminal Status LED colour
Standby Orange
Power Status
Power On Blue