Osoto PH-130W - Manual (Page 11)

●
Turn off:
When turn off, press 2 seconds,after heard of a voice
of“Bee”, this indicator will become from red shinning to red,
meansing getting into state of waiting, and visual presenter has
been turned off. If visual presenter has central controller function,
when turning visual presenter off, press this button 2
seconds, after a voice of “Bee”, power indicator shines fastly,
meanwhile visual presenter can not be controlled by any button.
When power indicator gets into shining slowly, press again
to turn off projector. After 2 minutes of “Bee”, it is into state of
waiting,at the same time projector’s power has been cut down
(delayed to turn off).
When it is into state of turning off,visual presenter will switch
“PC IN”（PC’s signal）into monitor automatically.（It is get through
without signal of turning on）.
●
Lamp Selection:
Press button,users can turn on/off assitant lamps or
baselight.
●
Preview/shooting:
Signal output to monitor（preview）:Press this button
repeatedly to select visual presenter’s signal, PC signal, and RGB
signal’s input.When select visual presenter’s signal, the indicator
will become red（other two indicators will be off）,when select PC
- 10 -