Dometic SEALAND 110 - Manual (Page 6)

6
SEALAND ToILET
bASE ASSEMbLY
bAND CLAMp
fASTENER
fLuSH bALL
SpRING
CARTRIDGE
WATER VALVE ASSEMbLY
Top VALVE CAp
fILTER SCREEN
WATER
VALVE
SCREWS
VALVE boDY
SHAfT
fLuSH pEDAL
pEDAL
CoVER
bAND
CLAMp
SEAL
DISK
SEALAND ToILET boWL,
REAR VIEW
VACuuM
bREAKER
WATER VALVE HoSE
CoNNECTIoN
VACuuM bREAKER/boWL CoNNECTIoN
TRoubLESHooTING GuIDE
1. Toilet emits odor (flush ball
open).
2. Water will not stay in bowl.
3. Flush ball will not close
completely.
a. Odor emitting from base of
toilet.
b. Plugged holding tank vent
line.
a. Loose band clamp.
b. Improper seal around flush
ball due to dirt or debris on
flush ball.
c. Worn or damaged seal.
d. Worn or damaged flush ball.
a. Too much friction between
flush ball and ball seal.
b. Water valve screws are too
tight.
a. Use SeaLand brand
deodorants.
b. Clear obstruction from vent
line.
a. Tighten band clamp fastener.
b. Inspect flush ball for foreign
debris. Clean flush ball if
needed.
c. Replace seal.
d. Replace flush ball.
a. Lubricate between flush ball
and seal with lubricant (e.g.
silicone spray, furniture polish).
b. Loosen screws slightly.
problem possible Cause Service Instructions
HAND SpRAYER
HoSE CoNNECTIoN*
STRAIN RELIEf
bRACKET*
* Applies only to toilet models
supplied with hand sprayers.