Measurement Computing WaveBook rev.4.0 - Manual (Page 25)

WaveBook User’s Manual 05-15-01 System Setup and Power Options 3-3
The WBK Card connects to headers J10 and J11 in the base unit. The base unit can be a WaveBook/512,
WaveBook/512H, WBK10 or WBK10H. The jumpers located on J10 and J11 provide signal pass-through
when a WBK option card is not installed. Refer to the following figure and steps to install an option card
into a WaveBook/512, WBK10, or WBK10H module.
Although the figure represents installation of a WBK11 into a WaveBook/512, the method
used to install other WBK options into a WaveBook, WBK10, or WBK10H is the same.
Installing a WBK Option Card
:$51,1*
Electric shock hazard! Remove the WaveBook, and all devices connected to it, from
power before removing the cover plate. Failure to do so could result in electric shock
and possible death.
1. Remove all power from the unit and any connected devices.
2. For WaveBook/512 series, WBK10, or WBK10H, remove the screw holding down the top panel
(cover), and slide the panel out towards the back (see following figure).
For WaveBook/516 and WBK10A, contact the factory in regard to adding or replacing option
cards.
3. Remove the stand-off screws, then remove old WBK card from J10 and J11.
If no card was present, skip to step 4.
4. Locate the headers J10 & J11 on the main board, and remove the jumpers (if present).
Save the jumpers in the event the SSH board needs to be removed.
5. Align the WBK card headers (P11 & P10) with the host board headers (J11 & J10), respectively.
6. Verify alignment of the board. An easy way is to check that the board’s screw holes are in line with the
standoffs.
7. Carefully push the WBK option card down until the connectors fully mate.
8. Using three screws, secure the WBK card to the standoffs. Do not over-tighten.
9. Slide the top panel onto the unit, and secure it using the top panel screw.