Measurement Computing eZ-TOMAS version 7.1.x - Manual (Page 19)

eZ-TOMAS & eZ-TOMAS Remote 988490 File Menu 2-8
Configuring the Project
A default configuration is automatically loaded when you open an eZ-TOMAS file. However, you may
want to make some changes to the configuration. To make changes:
1. From the eZ-TOMAS Main Window, open the Edit pull-down menu.
2. Select Project Information to open the associated window (following figure). Update
information and/or add notes as applicable.
Project Information Window
3. After the Project Information is as desired, click the button.
4. In the Edit menu select Configuration. The Setup Configuration window will appear
(following figure).
Reference Note:
The four tabs of the Setup Configuration window are labeled: Acquisition, Input Channels,
Spectral Bands, and Storage. They are discussed briefly in this section and in detail at the
beginning of Chapter 4, Edit Menu.