1) install software, 2) install and configure the pc-card – Measurement Computing Daq PC-Card User Manual
Page 20

1-12 Daq PC-Cards Quick Start Guide
01-11-00
457-0943, rev 1.2
(1) Install Software
1.
Remove previous version Daq* drivers, if present. You can do this through Microsoft’s Add/Remove Programs
feature by navigating from your desktop as follows: Start
⇒ Settings ⇒ Control Panel ⇒ Add/Remove Programs
2.
Place the Data Acquisition Software CD in the host PC’s CD-ROM drive.
Wait for PC to auto-access the CD.
This may take a few moments, depending on your PC.
3.
If a Licensing Agreement appears, read over the agreement, then click “Agree.” The Data Acquisition
Software Master Setup Screen appears (see following figure).
4.
On the Master Setup Screen, select Daq PC-Card Support.
If using DBK Cards, Windows3.1, or DOS, select 16-bit; otherwise select 32-bit.
5.
If you do not have Acrobat Reader version 3.0 or greater installed on your PC, select Acrobat Reader.
This will enable you to read and print documentation that is included on the install CD-ROM.
6.
Select DIAdem Post Acquisition Data Analysis Program. Refer to your separate DIAdem document
(p/n 457-0903) for information regarding this program.
7.
Click “Start Install.”
8.
Follow screen prompts
.
Note: If using DBK Cards, Windows3.1,
or DOS, select 16-bit;
otherwise select 32-bit.
Selecting Daq PC-Card Support, Acrobat Reader, and DIAdem
(2) Install and Configure the PC-Card
Install the PC-Card
1.
Ensure the Notebook PC is powered on.
2.
Insert the Daq PC-Card into the Notebook PC’s PCMCIA slot.
3.
Push the Daq PC-Card into the PCMCIA slot until the card makes full contact.
When the card properly engages you should hear a click and see the PC’s
socket-eject button extended.
4.
A “New Hardware Found” window should appear. You are now ready to
configure the card.
Insert this end of card into
the PCMCIA slot.