Daybreak Fitness WLRX10170 - Manual (Page 8)

8
HOW TO REMOVE THE MASSAGE PAD FROM
THE FRAME
If desired, the massage pad can be removed from the
frame and used on the floor or a bed. Follow the steps
below to remove the massage pad.
1. Unplug the power
cord from the
outlet. It is recom-
mended that you
also disconnect the
power cord from
the jack on the
massage pad.
2. Next, it is recom-
mended that you
disconnect the wire
harness on the
hand control from
the wire harness
on the massage
pad. To disconnect
the wire harnesses,
first press down the
indicated small
latch.
3. Fold the massage chair into the storage position.
Slide the massage pad off the seat frame and the
back frame. Note: There is a sleeve between the
massage pad and the frame. Be careful not to
remove the sleeve as you remove the massage pad.
HOW TO USE THE MASSAGE PAD ON A FLOOR
OR BED
After the massage pad is removed from the frame,
reconnect the hand control and the power cord to the
massage pad (see the drawings at the left).
Next, spread the massage pad flat on the floor or bed.
If desired, pillows can be placed under the massage
pad for added comfort. WARNING: Do not place a
blanket or pillow on top of the massage pad.
Excessive heating can occur and cause fire,
electric shock, or injury to persons.
To operate the massage pad, refer to pages 6 and 7
of this manual.
HOW TO ATTACH THE MASSAGE PAD TO THE
FRAME
To use the massage pad on the frame, it is recom-
mended that you first disconnect the power cord and
the hand control from the massage pad (see the
drawings at upper left).
Next, fold the massage chair into the storage position.
Slide the massage pad onto the frame (see the
drawing at the left). Make sure that the sleeve is
properly positioned between the massage pad and the
frame.
Finally, reconnect the hand control and the power cord
to the massage pad.
Massage Pad
Power Cord
Hand
Control
Massage
Pad
Massage
Pad
Back
Frame
Seat
Frame
Massage Pad
Latch