Q-See Computer Hardware - Manual (Page 60)

Error! Use the Home tab to apply
标题 1 to the text that you want to
appear here.
Error! Use the Home
tab to apply
标题 1 to the text that
you want to appear here.
SuperDVR & H.264 Series Cards
User Manual
60
higher quality setting.
7.2 Setting up Router for Internet Access
To access the dvr card over the internet you would need to forward ports 80,
1159, and 1160 on the router that you have the PC with the DVR card
installed attached to, to the IP address of the PC that has the card installed.
Notice: If you cannot use one of the HTTP ports, such as 80 because it is being
used by another program, or it is being blocked by your service provider, you
can use another port in the same range. If you do so then you need to forward
the IP address of the router to the other port, change the port in the SuperDVR
settings, and you need to add the port number after the IP address. For
example, if you set the HTTP port as 82, you need to enter the IP address as
192.168.0.25:82.
User name and password here are the same as that used on the DVR. The
default is admin and 123456.
To get the IP address of the PC go to the start button, then click on run, then
type cmd into the box and click ok. At the blinking cursor type in ipconfig. The
box will now display the IP address of the computer and the default gateway,
which is the IP address of the router. See Figure 7.2