Nuvo ESSENTIA NV-E6GXS - Manual (Page 34)

Slaved To Zone
None
Kitchen
Dining Room
Master Bedroom
Master Bath
Guest Room
Nursery
Remote Controls:
All
Remotes Enabled
NuVo Remote Only
All
Remotes Disabled
Slaved to Zone:
These settings affect the way the
Control Pad receives commands from a handheld
wireless remote. The NV-GRC1 is the system remote that
comes with the Grand Concerto. It allows the same level
of control as the Control Pad. At the default setting,
, this remote and any third-party IR
remote will be received by the zone's Control Pad. In
some instances, you may not want a third-party remote
command to be received by the Control Pad. In this case,
you would choose
. If the zone is in an
area that is flooded with sunlight or receives
interference from plasma displays, the best choice is
.
A feature of Grand Concerto is the ability
to slave zones together. This is most useful for
controlling a zone with more than one Control Pad, or
the converse, which is controlling more than one zone
with one Control Pad. Simply scroll to the zone you wish
to slave to and select it from the list, Fig. 45 .
Zone Number:
Slaved Zone
Diagnostic Self Test:
Each zone must be assigned a number or
specific zone address. This is done by scrolling to the
desired zone and selecting it. All used zone addresses
will be grayed out. If you have defined zones in the
Configurator Software, the actual zone names assigned
in the Zone tab of the software will appear in the list.
The zone list appears just as it does in the previous
menu. Scrolling to a different zone name
and pressing OK will set a new zone address, or
selecting NONE erases the zone address.
This performs a short display
parameter test when selected
Fig. 45
Fig. 46
Source Settings:
Gain:
NuVoNet Source:
Two choices reside in this menu, Fig. 46.
This lets you increase the audio input levels from
the sources coming into the Grand Concerto. This is not
necessary for the NuVoNet components, but if you use a
satellite or cable set-top box as an audio source for the
system, you will find that the audio level is inherently
softer and will benefit by the gain setting. The default is
0dB, with a range up to 18.75dB.
If you uncheck this selection, that
source will not be polled by NuVoNet and will only be IR
controllable.
Cur. Source Settings
Gain
NuVoNet Source
System Settings: This menu option controls system-wide
settings, Fig 47.
System Settings
Date/Time
24 Hour Time Display
Power-Off Mode
Fig. 47
*Advanced
30