Legrand 152CHA - Manual (Page 2)

2
Step 2 Remove cover plates by
removing (5) 8-32 screws. Step 3 Remove 3/4" plug from small
cover plate by rotating counter-
clockwise using a large straight
blade screwdriver. Install 3/4"
conduit fitting (provided) into
opening on large cover. Repeat
procedure for 2" conduit fitting,
on large cover plate. (provided)
NOTE: If necessary remove Feed Plates to pull communications wires through
Poke-Thru device. Replace Feed Plates when finished pulling wires.
Step 4 Feed 3/4" inch flexible conduit
into 3/4" conduit fitting on cover
plate. Feed power wires through
small compartment and into the
junction box. Make wiring con-
nections in the junction box.
Refer to copper cross section
chart to determine quantity of
wires to pass through each open-
ing. Attach cover to the flange
using (2) 8-32 x 3/8" screws. Step 5 Feed data wires through larger compartment and through
2" conduit fitting on cover plate. Refer to copper cross
section chart to determine quantity of cables to pass
through each opening. Attach cover to the flange using
(3) 8-32 x 3/8" screws.
Step 1 Place appropriate gasket
around Poke Thru and
slide under flange. Use
flat foam gasket for tile
applications or use round
neoprene gasket for
carpet applications.
Tile Gasket
Carpet
Gasket
INSTALLING COMPLETE ASSEMBLY
CAUTION: To maintain fire classification, Feed Plates must be installed. NOTE: Splices must be made in junction box.