Dimplex Electric Fireplace VCX1525 - Manual (Page 15)

15
Operation
Resetting The
Temperature Cutoff
Switch
should the heater overheat, an
automatic cut out will turn the
fireplace off and it will not come
back on without being reset. It
can be reset by switching the
Main On/Off Switch to OFF and
waiting five (5) minutes before
switching the unit back on.
CAUTION: If you need to
continuously reset the heater,
disconnect power and call
Dimplex customer service at
1-888-DIMPLEX
(1-888-346-7539).
Remote Operation
The fireplace is supplied with an
integrated on/off remote control
!
NOTE: Ensure that the
fireplace Main ON/OFF Switch
is set to the remote control
setting.
To operate, push the on button
to turn fireplace on, push the OFF
button to turn the fireplace off.
Battery Replacement (Figure 10)
To replace the battery:
①
slide battery cover open on
the hand held transmitter.
②
Install one (1) 12 Volt (a23)
battery in the battery holder.
③
Close the battery cover.
Figure 10
on
Button
off
Button
Battery
Cover
Battery
Battery must be recycled
or disposed of properly.
Check with your Local
authority or Retailer for recycling
advice in your area.