Standard magnet assemblies – BUG-O Systems DC IV v.2 User Manual
Page 15

15
NOTE: Use four magnet assemblies per 8' (2.37 m) section and use two
magnet assemblies per 4' (1.18 m) section.
MAGNET PLATE ASSEMBLIES mount on ARR rail quickly and conveniently
right on the work surface. Magnets cannot exert maximum pull on dirty ma-
terial. Remove excessive paint, scale and rust from the area on which the
magnets will be placed.
KEEP MAGNETS CLEAN - before positioning, wipe off magnetic particles
which adhere to the poles.
For
MAXIMUM HOLDING POWER on swivel magnets, press down on top of
each side of magnet...then rotate until it holds firmly. The magnet will retain
its magnetism indefinitely - to preserve the magnet casing, keep torch 4" (100
mm) away from magnets when burning. Use various thicknesses of keepers
to decrease the magnetic pull when required.
ARM-2248 - Magnet bar, short; compact for positioning in hard-to-reach or
restricted areas. This assembly holds up to 200 lbs. (91 kg) on a flat, clean
steel surface.
ARM-2010 - The New, Bug-O/ Mag-switch, Switchable On/Off Rare-Earth
magnet assembly provides for quick rail positioning without fighting the
magnet. The lighter weight, at just 1.7 lb. (.77 kg), less than all other magnet
assemblies, improves handling. 200 lb. (90 kg) holding capacity. Fits standard
ARR-rails.
ARM-2330 - Low profile magnet assembly with quick release lever; for use
on jobs that have height restrictions. This assembly holds up to 200 lbs. (91
kg) on a flat, clean steel surface.
STANDARD MAGNET ASSEMBLIES
ARM-2248
ARM-2325
ARM-2010