Artesyn SAM1411 Installation and Use (September 2014) - Manual (Page 46)

SAM1411 Installation
SAM1411 Installation and Use (6806800M91B) 46
4.4 Installing and Removing the Board
Since the backplane has no possibility to store the information (part number, serial number,
and so on.) on the shelf, this information is stored on the board itself. The software on the
board always updates this information on a newly inserted board.
4.4.1 Installing the Board
Installation Procedure
The following procedure describes the installation of the board. It assumes that your system is
powered. If your system is unpowered, you can disregard the blue LED and thus skip the
respective step.
1. Put on an ESD wrist strap.
2. Connect the strap to the shelf by attaching the front or rear ESD jack.
3. Set the rotary switches according to your needs (see Rotary Switch Settings on page
44 ).
Board Damage
Touching the board or electronic components in a non-ESD protected environment causes
component and board damage.
Before touching boards or electronic components, make sure that you are working in an
ESD-safe environment or wear ESD wrist straps.
 Never exchange more than one of these FRUs (boards) at the same time to guarantee
that the shelf information stays consistent and up to date.
 The board must only be operated in a shelf that is properly grounded.