IOTA I-232 - Manual (Page 2)

Page 2
7/8" BUSHING
FIXTURE
BALLAST CHANNEL COVER
PLASTIC TUBE
CHARGE INDICATOR
LIGHT
FIXTURE LENS
INSTALLATION INSTRUCTIONS
CAUTION: Before installing, make certain the A.C. power is off and the I-232 unit connector is disconnected.
1. MOUNTING THE I-232
Remove the ballast channel cover. For heat consideration, mount the I-232 in the ballast channel as far away from
the A.C. ballast(s) as possible. The I-232 may also be mounted on top of the fixture. The optional top mounting kit
(catalog no. TMK-80) may be ordered separately from Customer Service.
When battery packs are remote mounted, consult Customer Service for the maximum allowable distance between
the battery pack and lamps.
2. WIRING
Refer to the wiring diagrams on the back page for the appropriate wiring of lamps and ballast. Install in accordance
with the National Electrical Code and local regulations. For additional wiring diagrams consult Customer Service.
3. INSTALLING THE CHARGE INDICATOR
Recessed Troffer Fixture – Select a convenient location with proper clearance in the ballast cover and drill or
punch a 7 /
8
″ hole (½″ knockout). Insert the 7 /
8
″ bushing into the hole. Push the plastic tube through the bushing.
Disconnect the leads from the LED housing and route the leads down the plastic tube. Reconnect the leads to the
housing, observing the proper polarity (Red/Black or Red lead w/connector to positive (+) red tab). Push the entire
assembly back into the tube until the lens collar rests against the plastic tube. The plastic tube should be adjusted
so that the
Charge Indicator is within ¼ ″ of the fixture lens. The Charge Indicator must be visible after installa-
tion. Refer to Illustration 1.
Strip Fixture – Select a convenient location on the side of the fixture so the Charge Indicator can be seen after
installation. Allow for proper clearance inside the fixture and drill or punch a 1 /
2
″ hole. Disconnect the leads from
the LED housing. Push the LED housing into the ½ ″ hole until it is firmly locked in place. Reconnect the leads,
observing the proper polarity (Red/Black or Red lead w/connector positive (+) red tab). Refer to Illustration 2.
Illustration 1 Recessed Troffer Fixture
FIXTURE
CHARGE
INDICATOR
LIGHT
(POS LEAD)
RED/BLK OR
RED W/CONNECTOR
WHITE/RED
LEAD
+ RED
Illustration 2 Strip Fixture
I-232
OBSERVE PROPER POLARITY
I-232
4. INSTALLING THE TEST SWITCH
The Test Switch should be mounted on the ballast channel cover of a recessed troffer, or on the side of a strip
fixture, preferably adjacent to the Charge Indicator. Drill or punch a 1 /
2
″ mounting hole.
Note: For proper operation, use only the accessory components provided with the unit. See Page 1 of the Instruc-
tion Manual.