East Coast Supercharging ECS Alky C5 - Manual (Page 7)

2)Razor blade
3)Heat gun or lighter
Step 1
Strip insulation from end of pump cable and separate wires. Note there are
three wires. Red, Black, bare wire. Strip insulation Red and black wires.
About ¼ inch is fine. And use the small supplied Male spade terminals. Crimp
the terminals from the bottom as shown.
Step 2
Slide large black heat-shrink over terminals and cable. Next is slide white
heat-shrink over Bare wire, slide Red heat-shrink over Red wire. Slide Black
heat-shrink over Black wire. Then push male spades into their respective
colored female connectors as shown. Next is slide heat-shrink over terminals.