Dixon Grizzly SE 966516601 - Manual (Page 33)

OPeRaTION
33
Running
Release the parking brake by moving the lever 1.
downward.
NoTE: The mower is equipped with an operator
presence system. When the engine is running,
any attempt by the operator to leave the seat
without first setting the parking brake will shut
off the engine.
Move the steering controls to the neutral
2.
position (N).
The cutting height can be set from 1"- 5" 3.
(2.5 cm-12.7 cm) by setting the cutting height
pin into the desired hole. Release deck height
control by applying equal pressure to both
pedals.
Push foot pedal fully forward for transport
position. Set pin at desired cutting height. (Pin
is removed by rotating 180
o .) Push pedals again
to lower deck to selected setting.
8065-006
Release the parking brake
8065-017
Cut height selection pedals
8065-016
Set deck to selected cutting height