American Dryer Corp. 30 lb. Stacked Models - Manual (Page 19)

PREPARATION FOR OPERATION
The following items should be checked
before attempting to operate the dryer.
1. Read and follow all caution, warning
and direction labels attached to the
dryer.
2. Check incoming supply voltage to be
sure that it is the same as indicated on
the dryer data label located on the
rear side of the middle access
(control) door.
3. Check to assure that the dryer is
connected to the type of gas indicated
on the dryer data label.
4. The sail switch damper assemblies
are installed and preadjusted at the
factory prior to dryer shipment.
However, each sail switch adjustment
should be checked to assure that this
important safety control is functioning.
5. Check bolts, nuts, screws, terminals
and fittings for security.
6. Be sure all gas shut-off valves are in
the open position.
7. Be sure all back panels (guards) and
electric box covers have been
replaced.
8. Check all service doors to assure that
they are closed and secured in place.
9. Rotate the tumblers (drums) by hand
to be sure they move freely.
PREOPERATIONAL TEST
All dryers are thoroughly tested and
inspected before leaving the factory.
However, a preoperational test should be
taken before the dryer is publicly used. It
is possible that adjustments have changed
in transit.
1. Turn on electric power to dryer. Open
all gas shut-off valves.
WHITES I PERMT iOELICATE
COLORS 1 PRESS I FABRICS
HI ■ MED ■ LO
FABRIC-TEMPSETTINGS
WHITES ■ PERMT I DELICATE
COLORS
I
PRESS
I
FABRICS
HI ■ ■ LO
LOWER
DRYER
QUARTI
O.
0
COIN
RETURN
2. Computer System Operational Test.
a. Display(s) will flash back and forth
between
“FILL” and the amount
needed to start the dryer (i.e., “25”),
meaning the dryer is available and 25
cents is required to start it.
b. Insert the proper number of coins
into coin acceptor. Once the correct
amount needed to start the dryer has
been inserted, display(s) will read
“PUSH” ... “tEnP”.
c. Start the dryer by pressing the
desired setting for either the upper or
lower dryer tumbler (i.e.,“LO”
selection for upper dryer). Display will
now read selection (setting) made and
amount of time vended (i.e., “LO 10”).
NOTE: Dryer can be stopped at any
time by opening main door. To restart
dryer, shut main door and press
desired setting.
d. Open main door to stop dryer and
change selection to “MED” (medium)
setting. Repeat this procedure, but
change
selection (setting) to “HI”
(high). This will confirm that setting
key circuits and door switch circuits
are functioning properly.
NOTE: Selection (setting) changes can
be made at any time during the drying
cycle by opening and closing main
door and then making new selection.
17