Lint filter, Exhaust system – Amana LG1101 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LINT FILTER
The lint filter is located at the front of the dryer in the lower part of
the door opening. See illustration below.
CLEAN THE LINT FILTER BEFORE DRYING EACH LOAD. A clean
lint filter insures efficient drying.
The filter can be taken out to remove lint.
TO REMOVE LINT: Wipe across the filter with damp fingers.
TO REMOVE LINT FILTER: Lift filter up and out of door opening.
See illustration below. Filter may be washed if any residue is notic
ed on it.
TO REPLACE FILTER: Place filter in door recess and push in firmly.
Be sure to replace the filter with the words FRONT facing the front
of the dryer.
CAUTION - THE LINT FILTER MUST BE IN PLACE IN THE DOOR
OPENING WHEN USING DRYER OR LOADING AND
UNLOADING DRYER.
If the filter is not in place, clothing could fall into the front air duct
and get into the exhaust system and cause damage to the motor.
L I N T F I L T E R
EXHAUST SYSTEM
We recommend the dryer be exhausted to the outside atmosphere
to assure maximum drying efficiency. The exhaust duct should be
cleaned periodically to remove any obstructions. Check occasional
ly to make sure the flapper on the outside weather hood moves
freely, is not pushed in and that nothing has been shoved against it.
Check too that the flapper is not standing open.
-9-