Toa N-8650DS - Manual

INSTALLATION
MANUAL
IP DOOR STATION N-8650DS
Designed to connect to the IP network, the N-8650DS is an
indoor use door station featuring high quality hands-free
conversation. It is equipped with 1 contact input and 5
contact outputs, allowing connections to a sensor, electronic
lock, and other external equipment. The N-8650DS can be
mounted either flush in a wall or on a wall by using the
designated mounting box.
3. WALL MOUNTING
2. GENERAL DESCRIPTION
3.1. In-Wall Mounting
Mount the panel mount frame to the YC-150 Back box or 3-
gang electrical box installed in a wall, then attach the N-
8650DS to the panel mount frame.
Step 1. Loosen the screw on the N-
8650DS's bottom, then detach
the panel mount frame.
Step 2. Mount the panel mount
frame to the YC-150 or
electrical box.
3.2. On-Wall Mounting
Wall surface
Machine screw M4 x 20 (accessory)
YC-150 Back box or 3-gang
electrical box
Panel mount frame
The N-8650DS comes with 2 types of screws: machine
screw M4 x 20 and UNC No.6-32 x 20.
For the electrical box provided with unified threads, use the
oval head combination screws UNC No.6-32 x 20.
Accessory screws
• Before installation or use, be sure to carefully read all the
instructions in this section for correct and safe operation.
• Be sure to follow all the precautionary instructions in this
section, which contain important warnings and/or cautions
regarding safety.
• After reading, keep this manual handy for future reference.
1. SAFETY PRECAUTIONS
CAUTION
Indicates a potentially hazardous situation which, if
mishandled, could result in moderate or minor personal
injury, and/or property damage.
• Use the dedicated AC adapter or its equivalent for the unit.
Note that the use of other adapter may cause a fire.
Attach the N-8650DS to the YS-13A Wall-mount box
installed on a wall.
Step 1. Loosen the screw on the N-8650DS's bottom, then
detach the panel mount frame.
(Refer to Step 1 in the previous section.)
Step 2. Mount the panel mount frame to the back box.
The N-8650DS comes with 2 types of screws: machine
screw M4 x 20 and UNC No.6-32 x 20.
Use the M4 x 20 screw.
Accessory screws
55
163.5
92 46
116.5
83.5
6-φ4.5 (for wall mounting) 4-M4 (for N-8650DS mounting)
Unit: mm
[YS-13A dimensional drawing]
N-8650DS
Panel mount frame
Screw
Screw hole
Bottom view
Tab
Step 3. Attach the N-8650DS to the panel mount frame.
Hook the tabs on the N-8650DS's upper side into
the panel mount frame's slots, fit them into place,
then secure the both bottom sides with a screw.
YS-13A
Rear plate
Wall surface
Panel mount frame
Machine screw M4 x 20 (accessory)
Install the YC-13A
with its bottom
plate removed.
Step 3. Attach the N-8650DS to the panel mount frame.
Hook the tabs on the N-8650DS's upper side into
the panel mount frame's slots, fit them into place,
then secure the both bottom sides with a screw.
(Refer to Step 2 in the previous section.)
N-8650DS's bottom
Screw