All code scan method, Remember the code that worked – Cisco 8485DVB User Manual

Page 26

All Code Scan Method

1. Turn on the TV.

2. Press the

Mode

key on the remote control until the red LED on the Power key fl ashes twice.

3. Within 5 seconds, press

001

. The red LED will fl ash twice to confi rm the entered code.

4. Point the remote control toward the TV and press and hold the

Power

key until your TV turns off.

5. While the remote control is scanning the codes, you can release the

Power

key and test the function keys.

• If a key is not pressed within 10 seconds, the brand search is stopped and the remote control returns to
normal

mode.

• If the TV goes into Stand-By mode during the scan process, immediately release the

Power

key and

press

. The red LED will fl ash twice to indicate that the code is stored.

Tips:

• This process may take as long as 10 minutes.

• The remote control may fi nd several codes that operate your TV. However, if some function keys do not

work properly, repeat steps 1 through 5 until a code is found that operates all function keys.

• During the scan process you can press the

W key as many as fi ve times to select previous codes or

the

X key to search forward again.

Remember the Code That Worked

To fi nd out which code your remote control uses to operate your TV:

1. Press the

Mode

key on the remote control until the red LED fl ashes twice.

2. Press

002

. The red LED will fl ash twice to confi rm the entered code.

3. Press

; then, count the number of times the LED fl ashes. The number of fl ashes indicates the fi rst number

of the code.

4. Press

; then, count the number of fl ashes. The number of fl ashes indicates the second number of the code.

5. Press

; then, count the number of fl ashes. The number of fl ashes indicates the third number of the code.

Tips:

• Write the code here: ___________________________________________________________________ .

• If the LED does not fl ash after you press the keys, the code digit is 0.