Vermont Casting 360DVSL - Manual (Page 25)

25
360DVS Series Direct Vent Fireplaces
10006326
Lava Rock and Ember Material Placement
Your log set contains Ember Material and two types of
Lava Rocks. Set these materials in place after the logs
have been installed.
Ember Material (Pt. #51915)
Remove ember material from the bag and separate it
into small pieces, then scatter it over burner tiles in a
random fashion. Do not pack down ember material;
leave it in a ‘fluffy’ state.
Lava Rock (Pt. #10001454)
Remove lav rock material from packaging and spread it
over ceramic floor panels outside log stack. Do not
place this lava rock material on burner tiles.
Flame & Temperature Adjustment
RN/ RP Models
For units equipped with ‘HI/LO’ valves the flame
adjustment is accomplished by rotating the ‘HI/LO’
adjustment knob located near the center of the gas
control valve. (Fig. 42 and Fig. 43)
LO
HI
Turn
counterclockwise
to decrease
flame height
Turn clockwise
to increase
flame height
Fig. 42 Flame adjustment knob for Honeywell valve.
LO
HI
Turn
counterclockwise
to increase
flame height
Turn clockwise
to decrease
flame height
Fig. 43 Flame adjustment knob for SIT valve.
Flame Characteristics
It is important to periodically perform a visual check of
the pilot and burner flames. Compare them to the
pictorials illustrated below. (Fig. 44 and Fig. 45) If the
flame patterns appear abnormal, contact a qualified
service provider for service and adjustment.
3/8” - 1/2”
(10 - 13mm)
F584-703
Fig. 46 Correct pilot flame appearance.
B120
B121
B122
B123 B124
B126 B125
LG320
Fig. 40 360DVS log placement.
Side of Fireplace
V
enting Side
B120
B121
B122
B123
B126
B125
Side of Fireplace
V
enting Side
LG321
Fig. 41 360DVS log placement.
LG323
Fig. 45 Correct log flame appearance.
LG322
Fig. 44 Correct log flame appearance.