Jaypro Sports Stationary Backstops User Manual

Page 14

14 of 16

9. Insert rod. Twist during installation.
10. Fastener may be adjusted during specified gel time.
11. Do not disturb anchor between specified gel time and cure time.
12. Apply specified torque as required to secure items to be fastened. Do not exceed maximum

torque specified.

See applicable Hilti Kwik Bolt tables below for gel and cure time information. Remember to

consult Hilti directly for complete specifications and installation instructions. The information included
herein is intended as a guide only for assistance in proper anchor selection. HAS rod information
shown but other acceptable anchors are available from Hilti.

Figure 14: Gel and Cure Times for Kwik Bolt 3 (Adhesive Anchor)

Jaypro mandates a minimum of ½” diameter anchors. Information supplied here is limited to

that size anchor. See Hilti’s website or call Hilti directly for information on other size anchors.

Hilti, Inc. (US) 1-800-879-8000

Hilti (Canada) Corporation 1-800-363-4458