Cobra Electronics ESD-9570 - Manual (Page 7)

7
3
O P E R AT I O N • E A S Y S E T P R O G R A M M I N G
6
3
O P E R AT I O N • E A S Y S E T P R O G R A M M I N G
EasySet Programming
All user mode settings on your detector can
be changed by using Program mode. When
changing the settings, please keep in mind:
• Buttons can have multiple functions.
• All settings will be stored in memory
when the power is turned off and recalled
when the power is turned back on.
In general, the procedure for using Program
mode is as follows:
1. Press and hold the PROG/MUTE button
for 2 seconds to enter Program mode.
You will hear 3 beeps and
“
PROGRAM“ will appear in the
display. Then brief programming
instructions will scroll through the display
two times.
2. While the programming instructions
are scrolling, press and release the
SELECT/DIM button to cycle through the
user modes. You will hear 1 beep each
time you press the button. As each
mode is displayed, the current setting for
that mode will be shown.
3. With the user mode you wish to change
displayed, press and release the SET/CITY
button to change the setting. You will hear
either 1 or 2 beeps, depending on your
selection. To move to the next selection,
press SELECT/DIM again.
4. When you have finished programming
any or all of the user modes, press
and release the PROG/MUTE button to
exit Program mode. Or simply wait 10
seconds without pushing any buttons.
When you exit Program mode, the new
setting will automatically be saved and
“
EXIT PROGRAM” and “Settings
Saved!” will appear in the display.
EasySet Programming Menu
continued
N W
B r i g h t
c
s
NOTE: You cannot enter Program mode
during an alert. The unit will not detect
signals while in Program mode. During
programming, if no buttons are pushed for
10 seconds, the unit will automatically exit
Program mode and save the last settings.
Programming User Modes
The table below shows you how to program
all user modes and the settings you can
choose from.
NOTE: On the following pages, you will find
more detailed explanations of each setting.
See page 12 for instructions on setting the
IntelliMute activation point.
See page 15 for instructions on calibrating
the compass.
See page 17 for instructions on using
SmartPower.
P R O G R A M
2. Press and release the SELECT/DIM
button to cycle through the user modes.
Current mode setting is displayed. 3. Press and release the SET/CITY
button to choose the desired
setting for each user mode.
1. Press and release the PROG/MUTE button to enter Program mode.
MODE SETTING VISUAL RESULT
Set City Mode Default* City X A single beep sounds when the signal
is first detected.
City X Beep Off Audio for all X band alerts are blocked until
signal strength reaches level 3.
City X + K Combines the City X mode with
prevention of K band audio alerts until
signal strength reaches level 1.
IntelliMute Mode Intelli Mute On All alerts (except for strobe signals from
emergency vehicles) are automatically
muted below the engine rev point you set.
Intelli Mute Off Normal operation.
Set IntelliMute RPMs Press SET at desired RPMs... Allows you to set the engine rev point
(not shown if IntelliMute is off) (see page 12 to set activation point) when using IntelliMute.
S e t t i n g s
S a v e d !
E X I T
P R O G R A M