beautypg.com

Lights – HONDA 2000 Odyssey - Owner's Manual User Manual

Page 276

background image

Lights

5. Insert the new bulb into the hole,

making sure the tabs are in their
slots. Pivot the hold-down wire
back in place and clip the end into
the slot.

6. Install the rubber seal over the

back of the headlight assembly.
Make sure it is right side up; it is
marked "TOP."

7. Push the electrical connector onto

the new bulb.
Turn on the headlights to test the
new bulb.

8. (Driver's side)

Reinstall the air intake cover.

Replacing the Front Side Marker/

Turn Signal and Parking Light

Bulb

1. If you are changing the bulb on

the driver's side, start the engine,
turn the steering wheel all the way

to the right, and turn off the
engine. If you are changing the

bulb on the passenger's side, turn
the steering wheel to the left.

2. Use a flat-tipped screwdriver to

remove the two holding clips from

the inner fender.

3. Pull the inner fender away from

the fender and bumper.

CONTINUED

Maintenance

HOLDING CLIP

Main Menu

Table of Contents