Heckler&Koch VP9 User Manual

Page 15

Heavy Lube - Lubrication runs down the sur face when it is held in a ver ti cal position.

No heavy lube is required on the VP9 pistols.

Re-apply lubricant periodically during firing as it burns off from the heat. Apply lubricant

using a clean shav ing brush, cotton swabs, patches or rag. A spray bot tle of lubricant also

works well when using com pressed air to circulate the lubricant into all parts and to remove

the excess from the pistol.

TROUBLESHOOTING PROBLEMS AND REPAIR
Common causes of problems that are often overlooked include:

• Fouled or improperly lubricated pis tol

• Bad ammunition

• Damaged magazines

• Operator error

If your VP9 pistol still fails to function, please con tact HK Customer Service at 706-568-

1906 for the name and address of your nearest HK Au tho rized Re pair Fa cil i ty. Law

en forcement us ers, con tact your unit armorer or HK Customer Ser vice.

NOTE: If after reviewing this manual you still have ques tions, please contact HK

Customer Service at 706-568-1906 or by email: [email protected].

WARRANTY REGISTRATION
New HK firearms are covered by Heckler & Koch’s Limited Lifetime Warranty. Warranty

registration is now on-line. To register your new HK firearm go to:

http://hk-usa.com/warranty/register.html

If you don’t have access to the internet, contact HK Customer Service, TEL: 706-568-1906,

EMAIL: [email protected] to obtain a warranty card by mail.

SECTION 8 VP9 ACCESSORIES

RAIL MOUNTED ACCESSORIES

The VP9 has a full length MIL-STD-1913 (Picatinny) rail molded into the front, lower portion

of the frame (dust cover). This rail allows the operator to mount a wide variety of lights,

lasers aimers, and additional accessories to the handgun by means of the simple and

proven Picatinny interface system (see Figure 34).

Figure 34 — Accessory laser aiming module mounted on VP9

To avoid damage to the accessory and the VP9, carefully follow the instructions of the

manufacturer for installing, operating, and removing accessories from the mounting

rails. Always ensure the VP9 pistol is “clear” and unloaded before installing or removing

accessories.

NOTE: Weight of any frame (dust cover) mounted accessories should not exceed

5.64 ounces (160 grams) to ensure reliable function.

Most lights, laser aimers, and similar accessories are installed by sliding them onto the

front of the rail system while depressing a locking mechanism or clipping them on from

the bottom. Again, follow the installation instructions of the accessory manufacturer. If

encountering difficultly, please contact HK Customer Service to avoid damage to the pistol

or the accessory.

Figure 35 & 36 Installing accessory lights onto the rails