Golden Lighting 1821-M1L BI - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
7. Slip Canopy loop collar (H) over the chain, then do the
same with the canopy (G).
8. When ready to complete the installation Use the other
chain connector and attach the other end of the chain to
the canopy loop (F) and close the chain connector.
9. Make sure the weight of the chandelier will be supported
by the chain-not the electrical wire.
* You may now install the fixture.
Fig. 2
PARTS & ASSEMBLY SHEET
Fixture Name: Madera 1821-M1L BI
C
D
ASSEMBLING THE FIXTURE (Fig. 2)
4. Place the Socket/Top loop assembly (J) on
Glass shade (M/O).
5. Holding these pieces together, slide the Spacer
(Q) on socket and secure it by threading the Socket
ring (R) onto the threaded socket until tight.
6. By measuring determine correct number of links
needed for proper hanging height. Use a pair of
pliers to open one link of the Chain (K) then remove
the excess Chain (K) and discard it.
7. Use one chain connector (L) to attach one end of
the chain to the Top loop (J) and close the chain
connector.
8. Feed the fixture wires through the Chain (every
three links) and pull the wires until taut.
9. Slip Canopy loop collar (H) over the chain, then
do the same with the canopy (G).
10. When ready to complete the installation Use
the other chain connector and attach the other
end of the chain to the canopy loop (F) and close
the chain connector.
11. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.
* You may now install the fixture.
Note: Complete these remaining steps after the
fixture is hung.
12. Install the light bulb (not provided) in
accordance with the fixture's specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)
Bulb
(Not Provided)