Canon FAX-JX210P - Manual (Page 50)

49 Settings and Activity Reports
„ ACTIVITY REPORT
Summarizes the information for the sending and receiving activities of your fax after 20
transactions. For automatic printing, see on page 46.
Transactions in the ACTIVITY REPORT are listed chronologically.
„ ONE-TOUCH SPEED DIAL TELEPHONE NO. LIST
Lists the numbers and names registered under one-touch speed dialing buttons.
„ CODED SPEED DIAL TELEPHONE NO. LIST
Lists the numbers and names registered under coded speed dialing codes.
„ USER’S DATA LIST
Lists the current settings of the fax and the registered sender information.
„ MEMORY LIST
Lists the documents currently stored in the fax’s memory (see page 39).
„ TX REPORT (Transmission Report)
Normally the fax does not print an activity report for transmitting, but you can set the fax to print
an activity report every time you send a document. See on page 45.
You can set the fax to print an activity report only when an error occurs during transmitting. See
on page 45.
„ RX REPORT (Reception Report)
Normally the fax does not print an activity report for receiving, but you can set the fax to print an
activity report every time you receive a document. See on page 45.
You can set the fax to print an activity report only when an error occurs during receiving. See
on page 45.
„ MULTI TX REPORT (Multi Transmission Report)
Lists the result of a sequential broadcasting.
If you set the fax to print the TX REPORT and then use sequential broadcasting, the MULTI TX
REPORT will be printed instead of the TX REPORT. See on page 45.
Note
The MEMORY CLEAR REPORT is printed automatically when power is restored after a power
failure. See “MEMORY CLEAR REPORT” on page 73.