Belt changing and agitator cleaning, Warning, Electrical shock or personal injury hazard – Kenmore ASPIRADORA 116.34722 User Manual
Page 15: To remove nozzle cover, Personal injury hazard, To remove belt/clean agitator, Mwarning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BELT CHANGING AND AGITATOR CLEANING
m
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in elec
trical shock or personal injury from
cleaner suddenly starting.
Frequently check and remove hair, string
and lint build-up in the brush area. If build
up becomes excessive, follow the steps
below. Should the belt become loose or
should it break, follow the Belt Removal
Instructions.
TO REMOVE NOZZLE COVER
Disconnect electrical supply. Press handle
release pedal and rotate the handle down
so the cleaner is laying flat on the floor.
To protect the floor surface, always place
paper under the nozzle any time the nozzle
cover is removed.
Release the nozzle cover by rotating the
nozzle cover retainers to the UNLOCK
position. Grasp back of nozzle on each side
and lift up to remove it from nozzle cover.
Carefully remove any residue that may exist
in the belt area.
WARNING
Personal injury Hazard
Always unplug the vacuum cleaner
before cleaning the brush area as
agitator may suddenly restart.
Failure to do so can result in per
sonal injury.
TO REMOVE BELT/CLEAN
AGITATOR
Position hands on the agitator. If the belt is
stilt attached to the agitator, there will be
tension on it.
Carefully lift the right end of the agitator and
then lift the left end.
Remove the worn or broken belt from the
motor drive shaft.
M
WARNING
Personal Injury Hazard
Be careful when removing the agita
tor as the belt tension is high.
Failure to do so could result in per
sonal injury from the agitator releas
ing quickly and snapping away.
15