Dust bin filter changing / cleaning – Kenmore ASPIRADORA 116.34722 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
DUST BIN FILTER CHANGING / CLEANING
Check primary filter frequently and clean
when dirty. Remove the dust bin assembly
as outlined in the DUST BIN CLEANING
section and empty contents of dust bin.
Make sure dust bin is empty before filter is
removed. Grasp filter screen, rotate
counter-clockwise and lift out.
Grasp primary filter, rotate counter
clockwise and lift out. Clean primary filter
by gently tapping over a trash container.
Tap on several sides to ensure best
cleaning. (Rinse with water only as
needed) The filter may be cleaned by
tapping it on a firm surface or by rinsing it
under a faucet.
Rinse with water only, do not use detergent
or soap. Allow filter to dry 24 hours
before putting it back into the dust bin.
When the cleaning of the filter no longer
restores vacuum suction to full power you
need to replace the filter.
Before replacing the primary filter it is a good
idea to clean the inside of the dust bin and lid
area.
Alignment
Tabs
Rotate filter clockwise until slots lock onto
tabs in lid.
To re-instali the filter screen, align tabs on
filter screen with tabs on lid.
place.
12