To clean agitator, Important – Kenmore ASPIRADORA 116.25914 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum
cleaner, the agitator must be cleaned every
time the belt is changed.
The agitator must also be cleaned accord
ing to the following schedule:
Vacuum Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
IMPORTANT
Clean Agitator
every week
every month
every 2 months
Disconnect vacuum cleaner from
electrical outlet. Check and remove hair,
string and lint build-up frequently in the
Power-Mate® agitator and end cap areas.
Remove any dirt or debris In the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator, or end caps.
1. Install new
belt over motor
drive, then
over belt pul
ley.
M o tor
Dfive
B elt
P u lley
A g itato r B n d C ap
NOTE: See PARTS AND FEATURES for
belt number.
2. Place agitator
assembly back into
Power-Mate®,
3. Line up
front of cover
and base.
Rest cover
on front edge
of base as
shown.
Cover
B ase
4. NOTE: On dirt sensor models be sure
that the board is upright and the wires aref
tucked back as shown.
5. Rotate cover
back. Press
cover firmly until
side and rear
tabs snap into
place.
Make sure there
is no gap
between the
cover and base.
5. Turn Power-Mate®upside down and
replace two (2) cover screws.
R ear
L atch es
19