Kenmore 795.7937 - Manual (Page 12)

REFRIGERATOR INSTALLATION
REVERSE AND REATTACH REFRIGERATOR DOOR
• Using a %-inch socket wrench, loosen and remove
Hinge Pin from the Middle Hinge Pin Bracket.
Remove washer underneath the middle hinge and
set aside
NOTE: At this point the door will be loose, lift up
door slightly and remove it. (Fig. 20 and 20a).
Loosen and remove the 2 bolts and the
Phillips head screw to remove the Middle
Hinge Bracket from refrigerator housing
(Fig. 21). Set parts aside.
REMOVE base grill.
See BASE GRILL INSTRUCTIONS on page 8.
Remove the washer from the Bottom Hinge
Pin (Fig. 22).
Using a ■'A-inch socket wrench, loosen and remove
the Hinge Pin from the Bottom Hinge. Reattach
the Hinge Pin to the opposite side of the Hinge
(see Fig. 22 and 22a). NOTE: This is easier to do
while the Hinge is still attached.
Using 10mm or 13/32-inch socket wrench
with 2-inch extension, loosen the 3 bolts
and remove the Bottom Hinge from right
side of housing (Fig. 23).
12