Reverse freezer door, Refrigerator installation – Kenmore 795.7937 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REFRIGERATOR INSTALLATION
REVERSE FREEZER DOOR
• Gently pry off the Top Hinge Cover with a flat head
screwdriver and remove (see Fig.13).
Using 10mm or 13/32-inch socket wrench, remove
the 3 bolts and lift off the Top Hinge (see Fig. 14).
Set parts aside.
Lift up door slightly and remove it (Fig. 15).
Turn freezer door upside down on a non-scratch
surface and loosen the screw to remove Door
Closer/Stop and Hinge Pin Insert (see Fig. 16).
Move the Hinge Pin Insert Bracket to the other side
of the door, keeping the same orientation, and move
the Hinge Pin Insert into the hole on the left side
of the bracket (Fig. 17).
Reverse Door Closer/Stop by flipping over
(see Fig. 18), place on top of Hinge Pin Insert
Bracket, and tighten both down with the screw.
Pry off cover on top of refrigerator on left side to
uncover screw holes (Fig. 19).
Set freezer door and Top Hinge parts to the side
and remove refrigerator door.
11