BMW 2013 3 Series - Manual (Page 204)

Replacing the reversing lamp and inner
brake lamp
1. Loosen the two fasteners, arrow 1 and pull
down on the lamp holder to remove, arrow 2.
2. Press the defective bulb gently into the
socket, turn counterclockwise and remove.
3. Insert the new bulb.
Installing the bulb holder
1. Slide the bulb holder onto the two guide
pins, arrow 1. Insert the two contacts, ar‐
row 2, into the connections, arrow 3.
2. Press on the bulb holder. Make sure that the
two exterior fasteners latch into place.
3. Swing the trim back onto the trunk lid and
secure.
Tail lamp, license plate lamp and
central brake lamp
Follow the general instructions on lamps and
bulbs, refer to page
196 .
The lamps feature LED technology. Contact
your service center in the event of a malfunction.
Changing wheels
Notes
The vehicle equipment does not include a spare
tire.
When using run-flat tires or tire sealants, a tire
does not need to be changed immediately in the
event of pressure loss due to a flat tire.
The tools for changing wheels are available as
accessories from your service center.
Jacking points for the vehicle jack
The jacking points for the vehicle jack are lo‐
cated in the positions shown.
Vehicle battery
Maintenance
The battery is maintenance-free, i.e., the elec‐
trolyte will last for the life of the battery.
Your service center will be glad to advise you on
questions regarding the battery.
Battery replacement
Use approved vehicle batteries only
Only use vehicle batteries that have been
approved for your vehicle by the manufacturer;
otherwise, the vehicle could be damaged and
systems or functions may not be fully availa‐
ble.◀
After a battery replacement, have the battery
registered on the vehicle by your service center
Seite 204
Mobility Replacing components
204
Online Edition for Part no. 01 40 2 903 880 - 07 12 490