BMW 2013 3 Series - Manual (Page 201)

21-watt bulb, PY21W
1. In the wheel house, loosen the two brackets
and remove the cover.
2. If necessary, pull the inside trim of the wheel
house slightly inward. Turn the bulb holder
counterclockwise and remove.
3. Press the bulb gently into the socket, turn
counterclockwise and remove.
4. Install the new bulb and bulb holder in re‐
verse order of removal.
5. Attach the cover to the wheel house.
Front fog lamps
Follow the general instructions on lamps and
bulbs, refer to page
196 .
35-watt bulb, H8
1. Use the back side of the screwdriver from
the onboard vehicle tool kit to remove the
three wheel house panel screws, arrow 1.
Carefully raise the wheel house panel, ar‐
row 2.
2. Pull off the bulb connector, arrow 1.
Turn the bulb, arrow 2.
Left side of vehicle: turn clockwise.
Right side of vehicle: turn counterclockwise.
Remove the bulb.
3. Insert the new bulb, connect the connector
and screw on the wheel house panel.
Turn signal in exterior mirror
Follow the general instructions on lamps and
bulbs, refer to page
196 .
The turn signals feature LED technology. Con‐
tact your service center in the event of a mal‐
function.
Seite 201
Replacing components Mobility
201
Online Edition for Part no. 01 40 2 903 880 - 07 12 490