KEYENCE OP-87601 - Manual

Copyright (c) 2012 KEYENCE CORPORATION. All rights reserved.
12098E 1042-1 96M12098 Printed in Japan
Mouse Stand
OP-87601
Instruction Manual
Read this manual before use.
Keep this manual in a safe place after reading it so that it can be used at any time.
The OP-87601 is supplied with the following items. Check that all are included in the package.
F Stand . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
F Mounting screws (M3 x L10mm double sems screws x 4) . . . . . . . . . . . . . . . . . . . 1 set
F Instruction Manual (this document)
* We make every effort to ensure products reach our customers without any damage.
However, if you encounter any defective, damaged, or missing parts, please contact
your nearest KEYENCE sales office.
This is the instruction manual for the Mouse Stand, OP-87601.
To use the Stand, fix it to a metal plate with a thickness of 1.6 mm or more.
„ Symbols
This manual uses the following symbols so that you can recognize important messages at
a glance. Please read it in its entirety.
Refer to the diagram below to assemble the Stand.
1.
Make four holes of ø3.5 on the metal plate as shown below.
2.
Put the screw into the hole and fix it with the nut on the back side.
The recommended tightening torque is 0.7 to 0.9 N·m.
OP-87601
Stand weight: approximately 350 g
Checking the Package Contents
Introduction
It indicates a hazardous situation which, if not avoided, could result in
minor or moderate injury.
It indicates a situation which, if not avoided, could result in product
damage as well as property damage.
Installation
CAUTION
NOTICE
Recommended tightening torque: 0.7 to 0.9 N·m
Tab
Mouse storage
Keep hands away from the movable part when opening/closing the
Stand to prevent hands or fingers from being caught.
Do not put anything on the Stand other than the mouse.
Doing so may cause damage to the Stand or the mounting portion.
Dimensions
CAUTION
NOTICE
4-Elongate
hole (Note)
8
166
13 13 76 7.6
58
3.5 48
9.5
1.6
3
174 160
180
71
(Mounting
hole)
(Note) Details on the elongate hole (2/1)
12.8
16.8
96M12098