KEYENCE LB-70(W) Series - Manual (Page 5)

5
Beam attenuator Laser radiation emission warning
Aperture
[The above figure shows the appearance
of the LB-12(W).]
Beam attenuator Laser radiation emission warning
Aperture
[The above figure shows the appearance
of the LB-12(W).]
SAFETY PRECAUTIONS ON LASER PRODUCT PRECAUTIONS ON REGULATIONS AND
STANDARDS
CE Marking
Applicable Models: LB-11W/LB-70W and LB-12W/LB-72W
Keyence Corporation has confirmed that these products comply with the
essential requirements of the applicable EC Directives, based on the
following specifications. Be sure to consider the following specifications
when using these products in the Member State of European Union.
■ EMC Directive (2004/108/EC)
• Applicable Standard EMI: EN61326-1, Class A
EMS: EN61326-1
• The length of the cable connected to the Sensor head or the Control-
ler must be less than or equal to 30 m.
Remarks:
These specifications do not give any guarantee that the end-product with
these products incorporated complies with the essential requirements of
EMC Directive. The manufacturer of the end-product is solely responsible
for the compliance on the end-product itself according to EMC Directive.
For use with shield:
Attach the shielding cover to the front surface of the light source lens
and secure it using the supplied screw.
For use without shield:
Secure the shielding cover to the screw hole on the rear of the sensor
head using the supplied screw.