Connecting fm/am antennas, Connecting the power cord, Connections – Yamaha CINEMASTATION NX-C300 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connections
Connecting FM/AM antennas
;Fix the.claw..'- " . ■
■ ■ - ' into the slot '•. .
Connecting the power cord
DVD Receiver
Ilf
It
.©,
System Control Cable
□ OD
Subwoofer
p,Toan
AC
*'^wall
outlet
O
Connect the supplied AM loop antenna to the AM
ANT terminal. Place the AM loop antenna on a
shelf or attach it to a stand or wall.
0 Connect the supplied FM wire antenna to the FM
ANT terminal. Extend the FM wire antenna and fix
its ends to the wall.
For better FM stereo reception, connect an
external FM antenna (not supplied).
Notes;
-
Adjust the position of the antennas for optimal
reception.
- Position the antennas as far as possible from your TV,
VCR or other sources of radiation to prevent
unwanted interference.
After everything is connected properly, plug
the AC power cord into the power outlet.
Never make or change any connections with the
power switched on.
Note:
- Refer
to
the type plate on the rear of the DVD
receiver and subwoofer for idenPfication and supply
ratings.
15