Chemtronics Konform Flexcoat CTFC5 - Manual (Page 2)

product/component compatibility must be
determined on a non-critical area prior to use.
USAGE INSTRUCTIONS
For industrial use only.
Read MSDS carefully prior to use.
Before applying Konform

Flexcoat Conformal Coating,
clean circuit boards thoroughly to remove oil, grease,
dirt, flux and all other types of contamination. Allow to
dry. Cleaning may be performed with Chemtronics

Electro-Wash

or Eco-Rite™ degreasing products.
SPRAY APPLICATION: Apply top to bottom,
allowing coating to flow evenly around components.
Rotate PCB 90
° and repeat application. Rotate and apply
coating two additional times, then allow board to cure. If
additional thickness is desired, apply additional coatings.
When using liquid spray with automatic dispensing
equipment, adjustments may be required in application
rate and viscosity.
DIP APPLICATION: Using automatic equipment or
hand immersion technique, slowly immerse PCB into the
coating and remove slowly. Use an average rate of
approximately 1 foot per minute. After allowing the
board to cure, process may be repeated to achieve desired
thickness.
BRUSH APPLICATIONS: Evenly apply coating to
areas desired at thickness required. Allow time for curing
before reapplying to achieve a thick coating. Use
Chemask

to protect components during conformal
coating process.
CURING: Tack free time is 30 minutes at room
temperature. Accelerated curing can be obtained by
heating for 10 minutes @ 80
o
C in well ventilated
environments. Optimum cure cycles using radiant or
convection conveyer ovens are best determined
experimentally. Product may also be cured for 24 hours
@ 77
o
F (25
o
C). NOTE: Care must taken with
accelerated cures as the product solvents are
flammable.
REMOVAL: After application, cured Konform

Flexcoat Conformal Coating may be removed by peeling,
or soaking in Chemtronics Electro-Wash

Two Step.
AVAILABILITY
CTFC-12
11.5 oz. Aerosol
CTFC1 1 Gallon Liquid
CTFC5 5 Gallon Liquid
CTFC55 55 Gallon Liquid
TECHNICAL & APPLICATION ASSISTANCE
Chemtronics provides a technical hotline to answer
your technical and application related questions.
The toll free number is: 1-800-TECH-401.
NOTE
: This information is believed to be accurate. It
is intended for professional end users having the skills to
evaluate and use the data properly. CHEMTRONICS
does not guarantee the accuracy of the data and assumes
no liability in connection with damages incurred while
using it.
CHEMTRONICS
8125 COBB CENTER DRIVE
KENNESAW, GA 30152
1-770-424-4888
REV. B (08/13)
Chemtronics
, Chemask 
, Konform® and Electro-Wash

are registered trademarks of Chemtronics. All rights reserved.
Eco-Rite™ is a trademark of Chemtronics. All rights reserved.
Performance
Moisture Resistance Good
Removability Excellent
Ease of Repair Excellent
Flexibility Excellent
Adhesion Good
Abrasion Resistance Fair
Solvent Resistance Fair
DISTRIBUTED BY: