Satellite Tufway User Manual
Page 6
PN 10900/REV P
Page 5
DIRECTIONS
1.
JOIN PANELS TOGETHER WITH CORNER MOLDING
SET REAR PANEL ON A BOX AT LEAST 40” HIGH BUT NOT WIDER THAN 41”. IF ASSEMBLING
SINGLE UNITS, THE WASTE TANK WILL DO. ASSEMBLE ALL PUSH CAPS TO RIVETS BY HAND
THAN CLAMP USING THE C-CLAMP TOOL, MAKE SURE ALL RIVETS AND PUSH CAPS ON BOTH
PANELS ARE CLAMPED TIGHT.
2.
ATTACH BASE TO PANELS
TIP BASE UP AND POSITION INSIDE PANELS. USING THE DRILL AND 3/8" HEX DRIVER BIT.
FASTEN PANELS TO BASE WITH LAG SCREWS (PN 13860).
ROTOMOLDED BASE: LOCATE DIMPLES CIRCLED ON BASE AT LOCATION SHOWN. FASTEN
PANELS TO BASE WITH LAG SCREWS. FASTEN REMAINING HOLE.
DIRT BUSTER BASE:
FASTEN REAR PANEL FIRST. PANEL NEEDS TO BE FLUSH WITH TOP OF
RUNNER. USING THE CENTER SCRIBE LINE ON BASE FASTEN PANEL WITH LAG SCREW.
REPEAT ON EACH SIDE PANEL USING BOTTOM HOLES. SEE SCRIBE LINE LOCATION AS
SHOWN. FASTEN REMAINING HOLES. NOTE: MAKE SURE PANEL IS FLUSH WITH BASE
BEFORE FASTENING PANEL TO BASE.
ROTOMOLDED BASE DIRT BUSTER BASE