Canon LV-7245 - Manual (Page 25)

17
AUDIO IN
L R
AUDIO OUT
L R
Component
Y Cb Cr
AC IN
ANALOG IN-1 AUDIO IN
VIDEO IN L AUDIO IN R
S-VIDEO IN
ANALOG IN-1 ANALOG IN-2
AUDIO OUT L AUDIO IN R
MONO
MONO SERVICE PORT
AUDIO IN
2. Installation and Connections
You can connect your projector to a DVD player with component or composite video output. To do so, simply:
1. Turn off the power to your projector and DVD player.
2. If your DVD player has the component video (Y,Cb,Cr) output, use a commercially available component video cable
(RCA
ן3) and the optional 15-pin-to-RCA (female)ן3 cable to connect your DVD player to the ANALOG IN con-
nector on the projector.
For a DVD player without component video (Y,Cb,Cr) output, use common RCA cables (not provided) to connect a
composite VIDEO output of the DVD player to the Video Input of the projector.
3. Connect the supplied power cord. See page 19 .
4. Turn on the projector and DVD player.
A component signal will be automatically displayed. If not, from the menu, select [Advanced settings]
→ [Input
signal select]
→ [Computer], and then place a check mark in the COMPONENT radio button.
NOTE: Refer to your DVD player's owner's manual for more information about your DVD player's video output requirements.
Connecting Your DVD Player with Component Output
DVD player
Audio Equipment
Audio cable (not supplied)
Optional 15-pin - to - RCA (female)
ן 3 cable (LV-CA32)
Component video RCA ן 3
cable (not supplied)