Workrite Willow Dual-Wide Upgrade Instructions - Manual (Page 2)

2 Workrite Ergonomics 800.959.9675 www.workriteergo.com
Remove existing Willow Arm from Base
Loosen any monitor cables and remove from cable managers.
Remove and set existing monitor aside.
1
Remove Plastic Pivot Washer. e
Remove Arm Assembly from Pivot Pin. d
Remove ⅜" Steel Washer from ⅜" x 16 x 3½" Button Head Allen Bolt in
the Arm assembly and base. Loosen with 7 /
32
" Allen Wrench (N).
c
IMPORTANT! Loosen Set Screw in back of Desk Base with ⅛" Allen
Wrench(O).
b
Snap Pivot Cover Cap off top of Arm Assembly. Save for later. a
f
e
d
c
b
a
N
M
R
T
Q
O
Remove Pivot Pin from Desk Base Assembly. f
2
Attach Dual Splitter Bracket to Base
Attach Dual Splitter Bracket (P) to Base using Flat Head Screw (U).
Be sure the Splitter Bracket is aligned to the rear edge of the base
and tightened securely to keep the splitter from spinning before the
Allen set screw is tightened in the base.
a
Tighten Set Screw in back of Desk Base with ⅛" Allen Wrench (O). b
O
U
P
3
Attach Existing Arm with monitor to Splitter Bracket
Place the nut onto the bolt extending trough the splitter.
While holding the bolt with the 7/32" Allen wrench to keep to
bolt from turning and loosening, tighten the nylock nut firmly
to keep the bolt from loosening during use.
e
Thread the bolt into the splitter. Tighten until the arm is firm
but spins with light friction with the 7/32" Allen wrench (N).
d
Place the Button Head Screw (R) and Belleville Washer (T)
into the arm from the top.
c
Place the Plastic Washer (M) to go onto the Flange Pin (Q). a
a
b
c
d
Insert the Flange Pin into the bottom of the arm. b
e
b
a
N
Attach new Arm to Splitter Bar using the same method as above. f