Remote starting system — if equipped – Jeep 2011 Patriot - Owner Manual User Manual

Page 26

1. If the RKE transmitter is equipped with a screw,
remove the screw. With the RKE transmitter buttons
facing down, use a flat blade screwdriver to pry the two
halves of the RKE transmitter apart. Make sure not to
damage the elastomer seal during removal.

2. Remove and replace the battery. Avoid touching the
new battery with your fingers. Skin oils may cause
battery deterioration. If you touch a battery, clean it with
rubbing alcohol.

3. To reassemble the RKE transmitter case, snap the two
halves together.

NOTE:

If the RKE transmitter is equipped with a screw,

reinstall and tighten the screw until snug.

REMOTE STARTING SYSTEM — IF EQUIPPED

This system uses the Remote Keyless Entry
(RKE) transmitter to start the engine conve-
niently from outside the vehicle while still
maintaining security. The system has a range of

approximately 300 ft (91 m).

NOTE:

The vehicle must be equipped with an auto-

matic transmission to be equipped with Remote Start.

Separating Case Halves

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

This manual is related to the following products:

2011 Patriot