Electrical requirements for electric dryers, Option 3: optional 3-wire connection – LG ELECTRIC AND GAS DRYER D 5988W User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ELECTRICAL REQUIREMENTS FOR ELECTRIC DRYERS
Option 3: Optional 3-wire
connection.
• If your local codes or ordinances do not allow the
connection of a frame-grounding conductor to the
neutral wire, use the instructions under this
section.
1. Remove center terminal block screw.
2. Remove appliance neutral ground wire (white)
from external ground connector screw. Connect
appliance ground wire and the neutral wire (white
or center wire) of power supply cord/cable under
center, silver colored terminal block screw.
Tighten screw.
3. Connect the other wires to outer terminal block
screws. Tighten screws.
a.
External ground connector
b.
Neutral grounding wire (white)
c.
Neutral wire (white or center wire)
d.
Grounding path determined by a qualified electrician
4. Tighten strain relief screws.
5. Insert tab of terminal block cover into slot of
dryer rear panel. Secure cover with hold-down
screw.
6. Connect a separate copper ground wire from the
external ground connector screw to an adequate
ground.
1 8