Elegtrigal requirements for elegtrig dryers, Wlre receptacle (nema type10-30r), Wire receptacle (nema type14-30r) – LG ELECTRIC AND GAS DRYER D 5988W User Manual
Page 14: 3 wire direct, Wire connection : direct wire, 4 wire direct
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ELEGTRIGAL REQUIREMENTS FOR ELEGTRIG DRYERS
Review the following options to determine the appropriate eiectrical connection
for your home:
©
3-wlre receptacle
(NEMA type10-30R)
Use the instructions at this section if your home has
a 3-wire receptacle (NEMA type 10-30R) and you
will be using a UL listed, 120/240 volt minimum,
30 amp, dryer power supply cord.
4-wire receptacle
(NEMA type14-30R)
Use the instructions at this section if your home has
a 4-wire receptacle (NEMA type 14-30R) and you
will be using a UE listed, 120/240 volt minimum,
30 amp, dryer power supply cord.
"T— 3^2 ---------
(8.8 cm)
3 wire direct
If this type is available at your home, you will be
connecting to a fused disconnect or circuit breaker
box
4-wire connection : Direct wire
Important
: The places where a 4-wire connection
is needed are , for example, mobile homes and areas
that local codes do not admit the use of 3-wire
connections.
At least, 5ft(l .52m) of extra length is required in
order for dryer to be able to be moved.
Peel 5 in (12.7cm) of external covering from end
of cable, leaving bare ground wire at 5 in (12.7cm).
Cut 11/2 in. (3.8cm) from 3 remaining wires. Peel
insulation back bin. (2.5cm). Shape ends of wires
like a hook.
Then, put the hooked shape end of the wire under
the screw of the terminal block(hooked end facing
rightward) and pinch the hook together and screw
tightly.
4 wire direct
(12.7 cm)
If this type is available at your home, you will be
connecting to a fused disconnect or circuit breaker
box
I .Take off center terminal block screw
2. Take off appliance neutral ground wire(white) from
external ground connector screw. Fasten it under
center, silver colored terminal block screw.
3. Connect ground wire(green) of power supply cable
to external ground conductor screw. Tighten screw.
a.
External ground connector
b.
Green copper wire of power supply cord
c.
3/4 in. (1.3cm) UL-Iisted strain reiief
d.
Center silver-colored terminal block screw
e.
Neutral grounding wire(white)
f.
Neutral wire(white or center wire)