Canon 200E - Manual (Page 6)

All data are based on Canon’s Standard Test
Method.
Subject to change without notice.
Do not make any changes or modifications to the
equipment unless otherwise specified in the in­
structions. If such changes or modifications
should be made, you could be required to stop
operation of the equipment.
This equipment has been tested and found to com­
ply with the limits for a class B digital device, pur­
suant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential in­
stallation. This equipment generates, uses and
can radiate radio frequency energy and, if not in­
stalled and used in accordance with the instruc­
tions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to ra­
dio or television reception, which can be deter­
mined by turning the equipment off and on, the
user is encouraged to try to correct the interfer­
ence by one or more of the following measures;
Reorient or relocate the receiving antenna.
Increase the separation between the equip­
ments and receiver.
Consult the dealer or an experienced radio/TV
technician for help.
This digital apparatus does not exceed the Class
B limits for radio noise emissions from digital ap­
paratus set out in the Radio Interference Regu­
lations of the Canadian Department of
Communications.