To save a recording, Tips, Notes – Sony SLV-SE220G User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To save a recording
To prevent aeeidental erasure, break off the
safety tab as illustrated. To reeord on the
same tape again, eover the tab hole with
adhesive tape.
Tips
• To select a programme position, you can use the programme number buttons on the
remote commander. For two-digit numbers, for example, press 2 and 3 to select
“PR23.”
• If you connect additional equipment to a LINE connector orjack, you can select
the input signal using the INPUT SELECT or PROG +/- buttons.
• The© DISPLAY information appears on the TV screen indicating information
about the tape, but the information will not be recorded on the tape.
• If you do not want to watch TV while recording, you can turn off the TV. When
using a satellite or digital tuner, make sure to leave it on.
Notes
• The© DISPLAY information does not appear during still (pause) mode or slow-
motion playback.
• Ifa tape has portions recorded in both PAL and NTSC systems, the time counter
reading will not be correct. This discrepancy is due to the difference between the
counting cycles of the two video systems.
• When you insert a non-standard commercially available tape, the remaining time
may not be correct.
• The remaining time is intended for rough measurement only.
• About 30 seconds af^er the tape begins playback, the tape remaining time will be
displayed.
• To use the TV Direct Rec function, select SMARTLINK in the INSTALLATION
menu, then set TV DIRECT RECORD to ON.
38 Recording TV programmes