Sony CDX-T68PKG - Manual (Page 5)

Setting the clock
The clock has a 12-hour digital indication.
Example: To set the clock to 10:08
1
Turn the ignition key to the ON position.
2 Press ( DSPUCLOCK SET ) for more than
two seconds.
-:/.DD
The digit flashes.
O Press GD or CD to set the hour.
0 0
to go back to go forward
0 Press ( ENTEFVDELETE ) .
0 Press O or © to set the minute.
0 0
to go back to go forward
3
Press (DSPL/CLOCK SET).
ID:0B
The clock starts.
When the POWER SELECT switch on the hideatvay unit
is set to the "OFF" position, the clock display will not
appear on the display unit even if the ignition of your car is
turned on. In such a case, press the POWER switch of the
display unit and play a disc. Then follow steps 2 to 3.
Changing the transmitting
frequency
Because this unit processes CD/MD playback
sound through an FM tuner, there may be
interference noise during CD/MD playback. In
this case change the frequency of the
modulated RF signal transmitted from the
hideaway unit. The initial setting is 88.3 MHz.
1
Press ( ENTER/DELETE ) for more than two
seconds.
2
Press either © or © to select the
frequency.
Each time you press ©, the frequencies
change as follows:
88.3 MHz -► 88.5 MHz -► 88.7 MHz -►
88.9 MHz -► 89.1 MHz -► 89.3 MHz -►
89.5 MHz -► 89.7 MHz 89.9 MHz
If you press ©), the frequencies will be
displayed in reverse order.
3 Press (
ENTEFVDELETE
) for more than two
seconds.
Notes
* Be sure to set the frecjuency of your FM tuner to that of
the newly selected frequency.
• You can set the frequency, during CDIMD playback.
Changing the output level
1 Press ( ENTER/DELETE ) for more than two
seconds.
2 Press ( ENTER/DELETE ) again.
LEF
n m
Initial setting
3 Press CD# CD to select the output level.
LOW 4-p MID HIGH
4 Press ( ENTER/DELETE ) for more than two
seconds.
E
3-
fb
Q.
Note
You can change the output level, during CD/MD playback.