Two Brothers Racing Yamaha T-Max - Manual

Two Brothers Racing
Juice Box™ - Fuel Controller
2008-09 Yamaha T-Max 500 Installation & Operation Manual
Part # 008-246
Parts Incuded
Installation Instructions
Qty. Description Part Number
1 Juice Box™ Fuel Control Kit 008-246 (#9120230)
3 Zip Ties
1 Adhesive Velcro Square
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
6. Remove mounting hardware from right side lower cover
to be able to expose engine and wire harness. (Fig. 5)
7. Locate rubber boot with 4 wires going inside. (Fig. 6)
8. Disconnect the green and black two wire connectors one
at a time and connect the JUICE BOX™ connectors to
these connectors.
9. Plug JUICE BOX™ in the male and female ends. (Fig. 7)
Note: Connect the JUICE BOX™ with the RED, YELLOW
and WHITE wires to the GREEN conneectors. Connect the
GRAY and GREEN wires to the BLACK connectors.
10. Mount JUICE BOX™ on top cover. (Fig. 8-9) IMPORTANT - PLEASE READ CAREFULLY
Warranty
two brothers racing warrants that this product carries a warranty for 2 years from date of purchase against original
defects in materials and workmanship. should this product fail to perform for either of the above reasons, two brothers
racing will repair or replace it with an equivalent product at no charge, except for postage, to the original retail purchaser.
to obtain the benefits of this warranty, the retail purchaser must return the product and proof of purchase to the place of
original purchase.
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance
part, please consult with your local motorcycle dealer. Read all instructions
first before starting installation. Make sure the vehicle and exhaust system are
completely cool before starting the installation. Also, make sure the vehicle is
secure during installation. Be sure to save all stock components for possible use
later.
The Juice Box™ is legal ONLY for closed course race vehicles. The Juice Box™ is
not applicable, nor inteded for use on EMISSIONS CONTROLLED street, highway
or off-road vehicles. The Juice Box™ is not applicable, nor inteded for use on
aircraft.
Thank you for purchasing a genuine Two Brothers Racing
JUICE BOX™. This product represents a radical step
forward in tuning fuel-injected motorcycles and ATVs for
optimal performance using “load-based” technology.
We at Two Brothers Racing hope that you will find this
development as exciting and useful as we do. And
remember: Proper Fuel = Maximum Power!
1. Make sure the vehicle is completely cool before starting
the installation. Also, make sure the vehicle is secure and
will not roll around.
2. Remove right side body panel. (Fig. 1)
3. Remove center cover top and bottom. (Fig. 2)
4. Remove foot pad by pulling it upwards to expose bolts,
securing right lower cover. (Fig. 3)
5. Remove right side upper foot tray. (Fig. 4)
Continued on page 2
Fig 1
Fig 2
Fig 3
Fig 7
Fig 4
Fig 5
Wire Harness
Rubber Boot
Fig 6
Wires in
rubber boot
Fig 8
Fig 9