Cary Audio Design HD1080P - Manual (Page 15)

CONTROLS AND DISPLAYS
14
10. COMPOSITE VIDEO OUTPUT JACK
• Use this jack to connect to a TV, Monitor or AV receiver that has a composite VIDEO
input. Composite video connections use an RCA connector with 75 ohm cable for best
results (not included).
11. POWER INPUT (AC IN)
• Connect to an AC power supply using the included power supply cord.
12. DC TRIGGER INPUT TERMINALS
• Connect a device that can be triggered by DC + 12V trigger signal.
13. IR INPUT JACK
• Use this jack to connect external IR sensors.
14. RS 232 PORT
• The RS-232 port is used in conjunction with an external home automation remote
controller to control the operation of the DVD 7. (This is for custom installation use.
Consult your dealer for more information.)
15. DIGITAL OUTPUT JACK (COAXIAL)
• 44.1 kHz - 48 kHz digital data is output from this RCA coaxial digital output connection.
16. DIGITAL OUTPUT JACK (TOSLINK)
• 44.1 kHz - 48 kHz digital data is output from this optical digital output connection.
NOTE: Analog Audio Output: Pin assignments of the XLR-type male analog outputs:
Pin 1: Signal ground
Pin 2: Signal + (non-inverting)
Pin 3: Signal – (inverting)
Connector ground lug: chassis ground
Refer to your associated amplifier’s operating manual to verify that the XLR pin assignments
of its input connectors correspond to the XLR pin assignments for the analog XLR outputs of
the DVD 7. If the pin assignments are different, wire the XLR cable so that the appropriate
XLR output pin connects to the equivalent XLR input pin. We have wired this connector to the
AES/EBU (Audio Engineering Society/European Broadcast Union) standard.