Canon BJC-4400 - Manual (Page 50)

3-24 Paper Handling Chapter 3
❍ Let the printed fabric sheet set for about one hour to
allow the ink to completely dry.
❍ When dry, peel the film backing from the printed fabric
sheet. Do not remove the film backing before printing.
❍ Wash the printed fabric sheet for about three minutes
under lukewarm running water to remove extra ink.
❍ Hang the fabric sheet up to dry it again.
❍ Iron the dried fabric sheet with a clothes iron.
❍ See the booklet that comes with Fabric Sheet FS-101 for
details on drying and washing.
Printing on Banner Paper
For best results, use Canon Banner Paper.
To set up a print job on banner paper, you must decide on the number
of sheets you need. You can print banners from 2 to 6 sheets in length.
N
Always leave an extra sheet at the end of the banner—just in case the
type runs over.
The shaded portions of the drawing below illustrate the maximum
recommended printing area of banner paper.
Dry and
then wash the
fabric sheet.